Anyone who is passionate about woodworking or DIY would inevitably want to invest in a table saw. The table saw, named after the table that supports the material being cut, is an outstanding tool for performing repetitive cutting tasks quickly and precisely. If you’re in the market for one of these beauties or have already purchased one for your home workshop, learn how to use a table saw properly and safely. Table saws, which vary in price from $300 for a basic model to $700 for a contractor-grade model, are priced according to the size of the blades they can handle. While 10” table saws are the most popular and suitable for most carpentry and woodworking tasks, you can also find 8” table saws for small jobs and 12” table saws for deeper cuts on thicker materials.
Too many weekend warriors—as well as professionals—have been seriously injured because they don’t know how to use best table saw. The material being cut may get tangled and kicked back if not handled properly, either tossing the material at a high velocity toward them or jerking it aggressively and dragging their fingers toward the blade. Take the time to read the manufacturer’s safety provisions and always wear goggles and ear protection while using the table saw, in addition to the specific safety measures to avoid kickback. Remember to unplug the saw before changing or aligning the blade, and don’t remove the included safety guards. You can make specialty cuts like dado cuts, compound angles, and rabbet joints with accessories like clamps, stops, and jigs, but most woodworkers rely on the table saw for two simple cuts. The most common use of a table saw is ripping, which entails cutting material to a particular distance. Cutting material to a particular length is referred to as crosscutting. Below are step-by-step instructions for making each of these traditional cuts with a table saw. The table saw’s rip fence adjusts to the width of the desired cut and also acts as a guide to regulate the material when cutting, making ripping the easiest cut to make.
It’s important to note not to use the rip fence as a reference while making crosscuts on a table saw. Large lengths are stabilized by the rip fence, but most crosscuts are made on narrower material—cutting it in half or removing the end of a board, for example. Since there isn’t enough material to fit along the rip fence during crosscuts, using the fence raises the possibility of dangerous kickbacks. Using a miter gauge instead. A miter gauge has a guide fence to hold the material in place and a bar that fits into one of the table’s deep grooves. The entire miter gauge slides from the front to the back of the table saw when the bar is fitted into a groove, enabling you to monitor the cut. It also has a protractor-style guide that can be modified by loosening a knob, choosing the right angle, and then tightening the knob again. The miter gauge that comes with a table saw is often a little on the light side. Consider investing in a more substantial aftermarket miter gauge if you intend to do a lot of crosscutting.